March Update 2020 – Boiler Lift Appeal

 Boiler lift “Sponsor an inch or more” and prize draw.

As with all things in life what goes up must come down… and the boiler is no different. It will need to be lifted clear of the chassis, swung away, and then lowered to its new temporary location.

The approximate cost of the crane hire will be £1500 that also equates to approximately the distance in actual up and down travel of 150 inches of the boiler by the time it has been raised to clear the chassis and lowered again.

We are therefore offering supporters the opportunity to sponsor a part of the lift for as little as £10 per inch, of course supporters can also sponsor multiple inches!

How to “Sponsor an inch or more”

To “Sponsor an inch or more” head to our campaign ‘JustGiving’ page here  to complete your sponsorship.

Free prize draw

Every “inch or more” sponsored will be entered into a free draw to win a number of prizes, be drawn at random at pivotal points during the boiler lift, including: model railway locomotives in N and 00 gauges including a star prize of a Graham Farish N Gauge Merchant Navy Pacific locomotive, a year’s free membership of the GSNLR Society, General Stream Navigation merchandise and other prizes.

The more inches sponsored increases your winning chances.

Note: the prize draw is registered with Plymouth City Council in accordance with the Gambling Act 2005 for non-commercial Society’s

Click here to sponsor an inch

AGM Cancelled

We also regret to inform you that we have had to cancel our Society and C.I.C. AGM’s planned for Saturday March 28th. The Swindon and Cricklade Railway have cancelled their Steam Gala and all trains until at least the end of April as a precaution against Covid-19 and your Board has decided that we should follow their very sensible lead.

We hope to be able to arrange the AGM’s for a later date when the current situation resolves itself and we shall announce a new date in a future edition of The Packet and will be writing to all shareholders as well. We apologise for any inconvenience caused to any of you who intended to attend the AGM’s but I am sure you will understand our decision under the circumstances.

Engineering

Our volunteers have also been hard at work removing various components off the locomotive including the rear and middle brake hangers on the right hand side, the remaining parts of the slide bars from both sides, the outside exhaust steam pipes, the reversing screw and the regulator operating bar from inside the boiler. All of the removed components are then assessed, put into storage and if they are a component that is exclusive to the rebuilds they are offered to other Bullied owners group.

Trailing Truck

 Work was not just focused on removing components but also saw our volunteers test fit some of the components the Society had made last year. The main highlight was the trail fitting of all the components for the trailing truck. The spring beams were successfully installed with the hangers. The Society needs to acquire some new springs but was able to use the bogie springs for the test fiting. The axle box cover and dust cover were fitted which gave us the slight of a fully equipped fabricated trailing truck for the first time since the 1960s when GSN had the covers removed at Barry. The Society would once again like to thank all the members who sponsored the various components for the trailing truck.

Boiler

The main focus on the work on the locomotive has been centred around detubing the boiler ready for the boiler lift. As it stands all of the bigger boiler tubes have been removed from the boiler and our volunteers have a start removing the small tubes.

The boiler lift will be part of a big on-site move so getting the boiler prepared and the funds in place beforehand will be key. Once again if you like to help fund the boiler you can “Sponsor an inch or more”  by donating to our campaign ‘JustGiving’ page here  to complete your sponsorship.

As always thank you for your continued support.